Wire Harness terminal crimping must have a set of feeding organization, its structure is shown in the figure below, which consists of swing rod, return spring, terminal lever, feeding bottom plate, feeding plastic beauty board and terminal feeding fixture components, etc. . The whole process of its work is: while the guide rail slider moves left and right, the connecting crankshaft is moved left and right. When the connecting crankshaft sinks, the terminal lever is offset and located above the feeding plastic surgery board, which is in advance of feeding. In the preparation part, when the connecting crankshaft is displaced, the terminal lever is offset and located on the top of the feeding plate. During the whole process of the lever movement, push the terminal chain to move a terminal part in the direction of the mold, so that the terminal is just in the crimping position. The upper part of the upper mold of the mold is ready for crimping in advance. The structure of the terminal fixture component is shown in the figure below, which consists of tightening anchor bolts, terminal clamping blocks, racks, clamping screws, feeding troughs, feeding tables and tightening springs. Tightening the anchor bolts and tightening the springs can adjust the level of the terminal clamping block to clamp the terminal, and adjust it according to the specific working conditions, and it can be clamped after adjustment. The rack is used to replace the terminal. If the rack door handle is rotated from the vertical position to the horizontal position, the feeding trough will rise, which is convenient for the terminal replacement.
We support Custom Wiring Harness, and different wiring harnesses are doing it. You can also Custom Molded Cables, such as Molded Waterproofing Cable Assemblies and Custom molded wire assembly are available. More products can be viewed on our official website. Connectors System is also good to look at this.
